Installation & setup

Set up AlterGPS on iPhone

Prepare an iPhone, run the desktop-assisted setup, handle device trust and Developer Mode, and verify the connection.

8 minAktualisiert November 18, 2026Windows · macOS · Android · iPhone

Before you begin

  • Install and open AlterGPS on a supported Windows or macOS computer before changing the phone.
  • Use an iPhone running a supported iOS release and have its passcode available to approve trust prompts.
  • Use a USB data cable; some charging cables cannot carry device data.
  • On Windows, install current Apple device support when the desktop app prompts for it. macOS includes Apple device support, but may still ask for local-network or accessory permission.
  • Keep the iPhone unlocked and leave both applications open through the first desktop-assisted setup.

Start the desktop-assisted setup

  1. 01

    Open both applications

    Start AlterGPS on the same Windows or macOS computer where you will choose the iPhone, then open the AlterGPS action shown by your release for adding a mobile device.

  2. 02

    Connect the iPhone by USB

    Connect the cable directly to a computer port. Remove hubs or adapters during the first setup if the device is not detected.

  3. 03

    Unlock and trust the computer

    Unlock the iPhone. If it asks whether to Trust This Computer, tap Trust and enter the passcode when prompted. Only trust a computer you own or are authorized to use.

  4. 04

    Follow the desktop-assisted prompt

    Keep the iPhone connected and follow the instructions shown in AlterGPS and on the phone. Do not close either app while device preparation is in progress.

Enable Developer Mode when required

  1. 01

    Wait for the iOS prompt

    Some supported iOS releases require Developer Mode before a development-signed companion can run. The setting may stay hidden until the desktop-assisted setup begins.

  2. 02

    Restart if iOS asks

    If iOS says to restart before Developer Mode can be enabled, restart the iPhone and reconnect the USB cable after it powers on.

  3. 03

    Turn on Developer Mode

    Open Settings > Privacy & Security > Developer Mode when that section is available, review the system warning, and turn it on for the workflow you are authorized to use.

  4. 04

    Approve the required permissions

    Return to AlterGPS and approve only the location or local device access prompts displayed for the connection workflow.

Verify the iPhone connection

  1. 01

    Wait for the device card

    Return to the desktop app and wait for the iPhone name and connection status to appear. Keep the cable connected while pairing completes.

  2. 02

    Run one Place mode test

    Use a nearby, easy-to-verify destination before trying a route. Confirm that both the desktop status and the iPhone report the same position.

  3. 03

    Handle a missing trust prompt

    If the phone does not appear, lock and unlock it, reconnect the cable, and reset Location & Privacy trust only if you intentionally want macOS to ask again.

  4. 04

    Update safely

    Stop routes and disconnect wireless control before updating iOS or AlterGPS. If the app stops opening after an update, complete the current desktop-assisted setup again.

Weiterlesen

Noch Hilfe nötig?

Prüfe zuerst die Fehlerbehebung. Wenn das Problem bleibt, nenne App-Versionen, Gerätemodell und die genaue Fehlermeldung.

Fehlerbehebung öffnen